Close MenuDremel Small Engraving Cutter Model 107 Ball, 3/32
Dremel 107 Features:
Ideal for detail engraving, carving and routing in wood, fiberglass, ceramics, plastic, jewelry and soft metals
A high-speed cutter designed for precision engraving
Dremel 109 Engraving Cutter 1/16" Bit Diameter
Dremel 109 Features:
Ideal for detail engraving, carving and routing in wood, fiberglass, ceramics, plastic, jewelry and soft metals.
Secure objects to a stable surface while working.
For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
If chattering occurs, increase speed.
DREMEL HIGH SPEED 1/4 CUTTER 1/8
1/4" diameter, high speed cutter, 1/8" shank, made of high quality steel, use for shaping & hollowing most metals, plastics & woods.
Dremel 3000-1/25 Variable Speed Rotary Tool Kit
EZ Twist nose cap with wrench for fast accessory changes
Variable speed from 5,000 RPM to 32,000 RPM
Can be used with all Dremel accessories and most attachments
Cool-running ball bearing construction for smooth and quiet operation Replaceable motor brushes extend tool life
MANDREL
It is used primarily with sanding discs and cut-off wheels. Shank Diam: 1/8". Satisfaction ensured. Manufactured to the highest quality available.
Dremel 1/4" Drum Sander Mandrel w/Coarse Band
For rough shaping and smoothing wood and fiberglass this sanding drum comes in handy. The Drum Mandrel holds a Sanding Band covered with aluminum oxide abrasive. Sanding bands are easily replaceable on drums.
Applicable Materials: Wood, Fiberglass
Arbor Diam: 1/4 in
Shank Diam: 1/8 in
Type: Mandrel
6PC 1/4" 60 GRIT SANDING BAND
A cylinder covered with aluminum oxide abrasive that sits atop a mandrel with a 1/8 inch shank. The replaceable band covering the cylinder is available in extra fine (240 grit), fine (120 grit) or coarse (60 grit).
